Opaque Coatings

Dulux Gloss

Glossy Finish for Wood

Dulux Gloss

Superior quality synthetic enamel for wood & metal.

• Hard- wearing and washable
• Quick drying to maximize convenience

Dulux Gloss

Glossy Finish for Wood

Surface Preparation :
Clean and dry the surface. Remove all loose or poorly adhering materials by rubbing down using a suitable abrasive paper (Normally for rough use 180 no., and for finer finish 320 no. paper are used. May also be used in combination as required) followed by wipe off.

Priming :
Apply a coat of suitable solvent borne primer. For best results use ICI range of primers specific to surface and allow it to dry. Fill cracks and dents, if any, with appropriate solvent borne putty. Allow it to cut-dry and then sand it for leveling with suitable emery paper. Wipe clean and, apply another coat of primer. Allow the primer coat to dry overnight, for best results.

• Metal Surface - ICI Red Oxide Metal Primer (34-100)
• Wood Surface - ICI Wood Primer White (34-300) or ICI Pink Wood Primer (32-129)
• Masonry - ICI Solvent Based Cement Primer ( 34-200)
• Repainted Primer - Priming not required

Finishing :
Brush, Roller & Spray Application. Re-coatable in 4-6 hours. For best results re-coat after overnight maturity. Apply at least two coats for desired finish.

Thinning :
Brush or Roller - Ready to use. If required add up to 1 part White Spirit / Mineral Turpentine Oil ( MTO) to 10 parts of paint by volume. Conventional Spray - Add up to 1 part White Spirit / MTO to 15 parts of paint (15%) by volume.
Airless Spray – Follow recommendations of the equipment supplier, may take dilution up to 35%

STIR THOROUGHLY BEFORE USE

Dulux Gloss

Glossy Finish for Wood

• Flammable Material
• Store container in upright position, with lid tightly closed, in a cool, dry place away from ignition source
• In case of fire, use foam, dry powder, CO2. Never use water.
• Keep out of reach of children and away from combustible material, food, drink and animal feed
• May be harmful if swallowed. In case of ingestion seek immediate medical attention.
• Ensure good ventilation at all times. Do not breathe vapour or spray. Avoid inhalation of dust by wearing suitable nose pad during sanding and surface preparation.
• Wear eye protection during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• Avoid contact with skin. Repeated exposure may cause skin dryness or cracking. Remove splashes from skin with soap and water or a recognised skin cleanser.
• Do not pour leftover paint down the drain or in water courses.
• In the event of spills, contain spillage using sand or earth
• Safety Data Sheet available for professional user on request
• No added Lead, Mercury or Chromium compounds