Key Information
-
Finish Clear
-
Coverage 2.8-5.6 sqm/L
-
Drying Time 10-12 Hours
-
Coats 2
Product Features
- Silicone technology
- Anti algal & anti fungal
Product Description
Dulux Weathershield Clear Exterior Wall finish is a premium silicone based product for surfaces like absorbent, stone, brick, clay tiles to deliver the natural look over a longer time. It provides excellent water repellency and protection against all adverse weather conditions.
Application Description
Use Roller or Brush or Spray. For surfaces with normal porosity apply one liberal coat of Dulux Weathershield Clear by brushing evenly on the prepared surface. Allow the surface to dry overnight. Ensure that no small patches are being left out without the coating. Repeat brush strokes with heavy brush to ensure that the entire area is covered fully.
Health & safety
Hazard warnings
Flammable material. Store container in an upright position, with lid tightly closed, in a cool, dry place, away from ignition sources. In case of fire, use foam, dry powder, CO2, never use water. Keep out of reach of children and away from combustible material, food, drinks and animal feed. Avoid contact with skin. Remove splashes from skin with soap and water or recognised skin cleanser. Harmful: may cause lung damage if swallowed. If swallowed, do not induce vomiting, seek medical advice immediately and show the container or label. Use only in well-ventilated areas. Repeated exposure may cause skin dryness or cracking. Avoid release to the environment. Refer to special instructions/Safety Data Sheet. Do not empty into drains. Toxic to aquatic organisms, may cause long term adverse effects in the aquatic envronrment. Contain spilage using sand or earth. Safety Data Sheet available for professional user on request. No Added Lead, Mercury or Chromium compounds.
Tips & Advice
Preparing the Surfaces
Allow all new surfaces to dryout completely. Remove all loose dirt, debris, powdery residue, oil, grease, wax or any other contamination by thorough brushing and scraping, using a stiff wire or fibre brush followed by water jetting if required. Anything which prevents penetration should be removed. Fill up minor cracks and defects with cement and sand mixture for larger holes and cracks. Ensure that the surface is fully dry before application.
